Alarm 75:Program running, waiting for X14 signal for too long

sales06@switek.biz

+86 186 5927 5869

SWITEK SW8 Series Side Entry IML Robot Alarm Code and Solutions

Alarm 75:Program running, waiting for X14 signal for too long

After Y27 was turned on, X14 did not turn on for a long time.

Solutions:

Check if the T9 parameter setting is too small;
Please check if the demagnetization sensor switch behind the cylinder on the label side is on,Is there a label side retreat limit (X14);

警报75:【程序运行中，等待X14信号时间过长】

Y27 ON后，X14长时间未ON

处理方式:

检查T9参数设置是否过小
请检查送标气缸到位感应开关是否点亮，是否有到位感应开关（X14）

Tips: This alarm code and solutions is SWITEK SW8 series of side entry IML robot which include the SW830/SW831 for lids; SW832 for IML Containers; SW833 for lids and small size IML containers; SW850 for deep cavities containers like 20/33L paint buckets IML productions; SW860 for custom made IML solutions for special products etc.

SWITEK Automation 3 axis servo injection robot 16 Cavities elbow PVC pipe fittings runner cutting system put in production.

SWITEK 3 axis servo injection robot 16 cavities elbow PVC pipe fittings runner cutting system is an economic solution for the auto-production of PVC pipe fittings of small size around 25mm. The system has a 3 axis injection robot to pick the pipe fittings out and have the runner cutted and seperated automatically. It's one of the most widely used automation solutions for small PVC pipe fittings production in LESSO Group.