Alarm 49: M-arm is outside the safety zone

When the sensors on the take-out side or the placement side is not ON, the Primary arm is ready to go down. At a position beyond the take-out side area or the placement area, the Primary arm is ready to go down.

Solutions:

Please check the take-out side sensor (X04) and the placement side sensor (X18),in addition, please confirm whether or not the settings of the take-out side area and placement side area are appropriate.

在取出侧传感或置物侧传感器没有ON时正臂准备下降。在超出取出侧区域或置物侧区域的位置正臂准备下降。

处理方式:

请检查取出侧传感器（X04）及置物侧传感器（X18），另外确认取出侧区域和置物侧区域设置是否适当

Tips: This alarm code and solutions is SWITEK SW8 series of side entry IML robot which include the SW830/SW831 for lids; SW832 for IML Containers; SW833 for lids and small size IML containers; SW850 for deep cavities containers like 20/33L paint buckets IML productions; SW860 for custom made IML solutions for special products etc.

SWITEK Turn-key 4 Cavities Lids Side Entry IML Solutions @2.1s

Starting from $214,285

NPE 2024, is on coming againt after 3 yeears of time from May 6~10, 2024 at Orlando, FL. Many First-Timers include is getting excited for the opportunity to be engaged in this big event as an insider of plastic industry. I'm eager to meet the talents in injection machinery from around the world to share our experience in how to use plastic in a more efficient way but more friendly to our environment.

Since joined SWITEK in 2017, I had been in this innovative bussiness for more than 6 years and would say that I'm now an "Insider" of injection automation. I still remeber that how I was shocked for the first time in K-2019 that how are the plastic parts are shapped precisely but efficienty. And in every Chinaplast I'll always find something new in this dynamic business. But for NPE, it's my first time and for sure I'll learn a lot from my counterparts and provide much better service to our customers.

As one of the First-Timers, I'll visit NPE with our CTO Mr. Lee who is an expert of injection molding with an experience of more than 20 years' experience in injection automation. By visiting NPE with him we'll have a better understanding of what's happening in North America Plastic industry and revert back with a better injection automation solution for the North American Plasticers.

As a First-timer, I'm looking forward to meet you in NPE 2024 and hope that you'll leave a message to me if you're visiting this exciting exhibition too.

SWITEK SW8 Series Side Entry IML Robot Alarm Code and Solutions

Turn-key IML Solutions

Request for Quotation Now