Alarm 30: The ejector forward signal fault

sales06@switek.biz

+86 186 5927 5869

SWITEK SW8 Series Side Entry IML Robot Alarm Code and Solutions

Alarm 30: The ejector forward signal fault

After the forward movement of the ejector pin Y39 is turned on, the ejector pin detection signal X50 is not received

Solutions:

Please check the ejector forward output (Y39)and ejector forward input (X50)
If you do not need to detect the forward signal of the ejector pin, please turn off the detection function in the teaching program

警报30：顶针前进信号故障

顶针前进动作Y39 ON后，未收到顶针检测信号X50

处理方式:

请检查顶针前进输出(Y39)及顶针前进检测输入(X50)
如不需要检测顶针前进信号请在教导程序中关闭检测功能

Tips: This alarm code and solutions is SWITEK SW8 series of side entry IML robot which include the SW830/SW831 for lids; SW832 for IML Containers; SW833 for lids and small size IML containers; SW850 for deep cavities containers like 20/33L paint buckets IML productions; SW860 for custom made IML solutions for special products etc.

SWITEK Automation 3 axis servo injection robot 16 Cavities elbow PVC pipe fittings runner cutting system put in production.

SWITEK 3 axis servo injection robot 16 cavities elbow PVC pipe fittings runner cutting system is an economic solution for the auto-production of PVC pipe fittings of small size around 25mm. The system has a 3 axis injection robot to pick the pipe fittings out and have the runner cutted and seperated automatically. It's one of the most widely used automation solutions for small PVC pipe fittings production in LESSO Group.